Full arch implant placement on the maxilla using Simplant software

그림1

Author
Dr. Paweł Strzępek

Paweł Strzępek graduated from the Dentistry Division of the Medical University of Warsaw in 1990. He is a member of OSIS, ICOI and CEIA. Since 1990 he has been running a private practice for endodontics and implant dentistry.



슬라이드1
The patient was a 71 years old male with residual maxillary dentition using a partial denture of the upper arch.

슬라이드2
His teeth showed grade 2 mobility.

슬라이드3
To position the implants correctly a CBCT was performed and Simplant software was used to design the implant location.

슬라이드4


슬라이드5


슬라이드6
Before the procedure a wax up and mock up were made as well as a navigation splint and a splint for temporary restoration. Under infiltration anesthesia the residual teeth were extracted.

슬라이드7
Implants were immersed with the force of 35 to 45 Ncm.

슬라이드8


슬라이드9
A closed lift was performed for the Schneiderian membrane of the right maxillary sinus. Implant 16 was stabilized at 10 Ncm and was not loaded immediately. A temporary bridge was made at full occlusion on temporary connectors screwed to the implants with the force of 20 Ncm.

슬라이드10


슬라이드11


슬라이드12


슬라이드13
After stability was obtained (4.5 months) impressions were collected.

슬라이드14


슬라이드15
The metal framework supported by standard connectors was tried in.

슬라이드16


슬라이드17
The restoration was then produced and finally cemented.

To position the implants correctly a  CBCT was performed and Simplant software was used to design the implant location on residual maxillary dentition.

564 Total Views 6 Views Today
0 Comments

Leave a reply

CONTACT US

We're not around right now. But you can send us an email and we'll get back to you, asap.

Sending

Copyright (c) GAO Forum. All Rights Reserved.

 

Forgot your details?