GBR technique using autogenous bones and titanium mesh

Dr. Pavel

Author
Dr. Pavel Yaroshevich
St. Petersburg, Russia



64C02
The narrow ridge was found with a crestal incision.

64C03
Parallel pin was placed to measure the position of implant placement.

64C04
Buccal view

64C05
Auto Chip Maker (ACM)

64C07
Autogenous bone chips were harvested using an Auto Chip Maker at 50rpm. Water irrigation was not applied.

64C06
Buccal view of the donor site

64C08
64C09
1mm CTi-mem and B type of Cti-mem bent to be placed over the graft.

64C10
The harvested bone chips were applied to the defect and B type of Cti-mem was placed over the graft using a fixing screw.

64C11
Occlusal view

64C12
The wound closure was achieved with sutures.

64C13
Tissue healing at 12 weeks

64C14
Uncovery was done for the stage Ⅱ surgery and the Cti-mem was easily removed.

64C15
It was verified that the volumetric stability of the bone graft was achieve.

This case presents how to augment the narrow ridge with the autogenous bone harvested with an Auto Chip Maker (ACM) and CTi-mem Titanium Mesh. 12 weeks follow-up shows verification of the volumetric stability of the graft.

2216 Total Views 1 Views Today
1 Comment
  1. Profile photo of YoungKu Heo
    YoungKu Heo 2 years ago

    Very nice result at 12 weeks! Thanks for sharing.
    Regards
    Dr. Heo

Leave a reply

CONTACT US

We're not around right now. But you can send us an email and we'll get back to you, asap.

Sending

Copyright (c) GAO Forum. All Rights Reserved.

 

Forgot your details?